Installation & Commissioning
Mechanical installation, electrical termination, hydraulic testing and documented performance handover — the plant is not signed off until it meets its design figures.
Service & support
The work that decides whether it still performs in year five
A water treatment plant is process equipment, not an appliance. It needs measurement, cleaning and parts on a schedule — and someone accountable when it stops.
What we do
Five services, covering the whole asset life
From the day a plant is installed to the day it is retrofitted rather than replaced. We work on equipment from any manufacturer, not only our own.
System Health Check
A measured diagnostic of an existing plant — water tested, performance compared against design, and a written report with costed recommendations.
Upgradation & Retrofitting
Targeted upgrades that restore performance and add capacity to an existing plant — usually at a fraction of what full replacement costs.
Annual Maintenance Contract
Scheduled preventive servicing, priority breakdown response and predictable annual cost — so plant performance stops depending on someone remembering to check it.
Repair & Breakdown Service
Rapid diagnosis and repair when a plant stops — with the root cause identified so the same failure does not return next quarter.
We service what we did not sell
A large share of our service work is on third-party equipment, usually where performance has fallen away and the original supplier is no longer engaged.
Diagnosis before parts
Swapping the obvious component is guesswork. We identify the root cause, because a membrane that failed from poor pre-treatment will fail again on the same schedule.
Findings in writing
Every visit produces a report with measured figures and costed recommendations — including, where it applies, the finding that nothing needs doing.
Plant not performing the way it used to?
A health check measures what it is actually doing and tells you what it would take to put it right.